HIKVISION DS-KD8003-IME2 User Manual

Note
●
Make sure you have congured the room No. of the device.
●
Make sure you have add contacts to the device via iVMS-4200
Client Soware.
Call Resident via Main Module or Nametag
Module
Press the call buon on the main unit or on the nametag unit.
Call Resident via Keypad Module
Enter the Room No. on the keypad module, and press # to start
calling.
Note
You can press * via keypad module to hang up.
Call Resident via Display Module
Press on the display module to enter the contact list.
Figure 8-1 Contacts
Press or hold ˄/˅ to select a contact.
Press OK and conrm to call.
Note
●
Hold ˄ or ˅ to scroll the page up or down faster.
●
You can press Back buon via display module to hang up.
Call Resident via Touch-Display Module
You can call corresponding resident in the two ways. They are:
●
On the main page of the touch-display module, tap and
enter the No. to call.
78

HIKVISION DS-KD8003-IME2 Specifications

General

Megapixel	2 MP
Maximum frame rate	30 fps
Supported video modes	720p, 1080p
Viewing angle, vertical	96 °
Maximum video resolution	1920 x 1080 pixels
Viewing angle, horizontal	180 °
Video codecs	H.264
Number of buttons	1 buttons
Streaming capability	Yes
Connectivity technology	Wired
Maximum number of cameras supported	-
Voice codecs	G.711u
Product color	Black, Grey
International Protection (IP) code	IP65
Operating relative humidity (H-H)	10 - 95 %
Door station operating temperature (T-T)	-40 - 60 °C
Indoor unit included	No
Outdoor unit power type	DC
Display diagonal	- \
Harmonized System (HS) code	85176920