HIKVISION DS-KD8003-IME2 - Page 96

Because 10.1 W ≤ 16 W, we can support powering this device
through KAD706 channel 6 or KAD704 channel 4.
2-Wire
Model
DS-KD8003-
IME2
DS-KD-M DS-KD-KK /
Quanty 1 1 12 /
Power 4 W 0.8 W 9.6 W
Total: 14.4
W
Because 14.4 W ≤ 16 W, we can support powering this device
through KAD706 channel 6 or KAD704 channel 4.
Wire Tesng Standards
●
When there are mulple cores in one parallel line, only one
pair of closed cores are allowed to transmit signal. It is not
allowed to use mulple pair of cores in one cable to transmit
signal.
●
When using parallel lines, it is suggested to use those with
shielding layer. If dual core or
mulple core parallel lines
without shielding layer are routed, stability of signal
transmission can be
eected. You need to run a test before
installaon.
●
Impedance of twist pair in network cable are over 42 Ω/100 m,
so network cable cannot transmit enough power to indoor
staon. Network cable is not allowed to use during installaon.
●
Strong electricity and weak electricity cannot be wired in the
same route, they need to be wired separately and the distance
should be more than 0.5 meter.
Table A-1 Table A
Roun
g Path
Twiste
d Pair :
24
AWG
(0.2
mm
2
)
Twiste
d Pair :
20
AWG
(0.5
mm
2
)
Twiste
d Pair :
18AW
G (0.8
mm
2
)
Twiste
d Pair :
16AW
G (1
mm
2
)
Parallel
lines
(0.5
mm
2
to 0.8
mm
2
)
DS-
KAD70
6-S-DS-
KAD70
6
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 50
m
Transm
ission
Distanc
e ≤ 35
m
DS-
KAD70
6-DS-
KAD70
6
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 60
m
Transm
ission
Distanc
e ≤ 50
m
Transm
ission
Distanc
e ≤ 35
m
DS-
KAD70
Transm
ission
Distanc
Transm
ission
Distanc
Transm
ission
Distanc
Transm
ission
Distanc
Transm
ission
Distanc
86