HIKVISION HWN-2100H Series - Page 143

Network Video Recorder User Manual
142
User Permission Settings Interface
Set the operating permission of Local Configuration, Remote Configuration and
Camera Configuration for the user.
Local Configuration
 Local Log Search: Searching and viewing logs and system information of NVR.
 Local Parameters Settings: Configuring parameters, restoring factory default
parameters and importing/exporting configuration files.
 Local Camera Management: The adding, deleting and editing of IP cameras.
 Local Advanced Operation: Operating HDD management (initializing HDD, setting
HDD property), upgrading system firmware, clearing I/O alarm output.
 Local Shutdown Reboot: Shutting down or rebooting the NVR.
Remote Configuration
 Remote Log Search: Remotely viewing logs that are saved on the NVR.
 Remote Parameters Settings: Remotely configuring parameters, restoring factory
default parameters and importing/exporting configuration files.
 Remote Camera Management: Remote adding, deleting and editing of the IP
cameras.
 Remote Serial Port Control: Configuring settings for RS-232 and RS-485 ports.
 Remote Video Output Control: Sending remote button control signal.
 Two-Way Audio: Realizing two-way radio between the remote client and the
NVR.
 Remote Alarm Control: Remotely arming (notify alarm and exception message to
the remote client) and controlling the alarm output.
 Remote Advanced Operation: Remotely operating HDD management (initializing
HDD, setting HDD property), upgrading system firmware, clearing I/O alarm
output.
 Remote Shutdown/Reboot: Remotely shutting down or rebooting the NVR.
Camera Configuration