HIKVISION NETWORK CAMERA User Manual

User Manual of Network Camera
154
Figure 12-10 Security Service
2. Check the checkbox of Enable SSH to enable the data communication security,
and uncheck the checkbox to disable the SSH.
3. Check the checkbox of Enable Illegal Login Lock, and then the device will be
locked if you input the incorrect user name or password for 5 continuous times.
Note: If the device is locked, you can try to login the device after 30 minutes, or
reboot the device first before retry.
12.6 Viewing Device Information
Enter the Device Information interface: Configuration > Basic Configuration>
System > Device Information or Configuration > Advanced Configuration>
System > Device Information.
In the Device Information interface, you can edit the Device Name.
Other information of the network camera, such as Model, Serial No., Firmware
Version, Encoding Version, Number of Channels, Number of HDDs, Number of
Alarm Input and Number of Alarm Output are displayed. The information cannot be
changed in this menu. It is the reference for maintenance or modification in future.

HIKVISION NETWORK CAMERA Specifications

General

Operating Temperature	-30 °C to 60 °C (-22 °F to 140 °F)
Lens	Fixed or varifocal (depending on model)
Compression	H.265+, H.265, H.264+, H.264
Audio	Built-in microphone and/or audio input/output (depending on model)
Network	Ethernet (RJ-45)
Power Supply	PoE or DC 12V (depending on model)
Weatherproof	IP66 or IP67 (depending on model)
Image Sensor	CMOS (depending on model)
Smart Features	Motion detection, line crossing detection, intrusion detection
Storage	MicroSD card slot (up to 256GB), NAS
Network Interface	10/100 Mbps Ethernet