HIKVISION NETWORK CAMERA User Manual

User Manual of Network Camera
77
Some of the camera supports CVBS, SDI, or HDMI output. Please refer to the actual
camera model for details.
Day/Night Scheduled-Switch
Day/Night scheduled-switch configuration interface enables you to set the separate
camera parameters for day and night to guarantee the image quality in different
illumination.
Figure 6-37 Day/Night Scheduled-Switch Configuration Interface
Steps:
1. Click the time line to select the start time and the end time of the switch.
2. Click Common tab to configure the common parameters applicable to the day
mode and night mode.
Note: The detailed information of each parameter please refers to day/night auto
switch session.
3. Click Day tab to configure the parameters applicable for day mode.
4. Click Night tab to configure the parameters applicable for night mode.
Note: The settings saved automatically if any parameter is changed.
6.5.2 Configuring OSD Settings
Purpose:

HIKVISION NETWORK CAMERA Specifications

General

Operating Temperature	-30 °C to 60 °C (-22 °F to 140 °F)
Lens	Fixed or varifocal (depending on model)
Compression	H.265+, H.265, H.264+, H.264
Audio	Built-in microphone and/or audio input/output (depending on model)
Network	Ethernet (RJ-45)
Power Supply	PoE or DC 12V (depending on model)
Weatherproof	IP66 or IP67 (depending on model)
Image Sensor	CMOS (depending on model)
Smart Features	Motion detection, line crossing detection, intrusion detection
Storage	MicroSD card slot (up to 256GB), NAS
Network Interface	10/100 Mbps Ethernet