Safety Instrucon
These instrucons are intended to ensure that user can use the product correctly to avoid danger
or property loss.
The
precauon measure is divided into Dangers and Cauons:
Dangers: Neglecng any of the warnings may cause serious injury or death.
Cauons: Neglecng any of the cauons may cause injury or equipment damage.
Dangers: Follow these safeguards to prevent
serious injury or death.
Cauons: Follow these precauons to prevent
potenal injury or material damage.
Danger:
●
In the use of the product, you must be in strict compliance with the electrical safety regulaons
of the naon and region.
●
CAUTION: To reduce the risk of re, replace only with the same type and rang of fuse.
●
CAUTION: This equipment is for use only with Hikvision’s bracket. Use with other (carts, stands,
or carriers) may result in instability causing injury.
●
To prevent possible hearing damage, do not listen at high volume levels for long periods.
●
Please use the power adapter, which is provided by normal company. The power
consumpon
cannot be less than the required value.
●
Do not connect several devices to one power adapter as adapter overload may cause over-heat
or
re hazard.
●
Please make sure that the power has been disconnected before you wire, install or dismantle the
device.
●
When the product is installed on wall or ceiling, the device shall be
rmly xed.
●
If smoke, odors or noise rise from the device, turn o the power at once and unplug the power
cable, and then please contact the service center.
●
If the product does not work properly, please contact your dealer or the nearest service center.
Never
aempt to disassemble the device yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)
Cauons:
●
+ idenes the posive terminal(s) of equipment which is used with, or generates direct current.
+
idenes the negave terminal(s) of equipment which is used with, or generates direct
current.
●
No naked ame sources, such as lighted candles, should be placed on the equipment.
●
The USB port of the equipment is used for
connecng to a USB ash drive only.
●
The serial port of the equipment is used for debugging only.
Face Recognion Terminal User Manual
vi