Hill-Rom Isolette C2000 - Page 52

Alarms
Chapter 2: Troubleshooting Procedures
For an explanation of temperature alarms, refer to table 2-2 on page 2-18.
Table 2-2. Temperature Alarms
Alarm
Description
Low air temperature This message appears with an audible alarm and
flashing alarm indicators to indicate that the
incubator air temperature is 2.5°C below the air set
temperature. To silence this alarm for 15 min,
press the Silence/Reset key. Go to RAP 2.3.
High air temperature This message appears with an audible alarm and
flashing alarm indicators to indicate that the
incubator air temperature is 1.5°C above the air set
temperature. Additionally, the heater is turned off.
To silence this alarm for 15 min, press the
Silence/Reset key.
Skin mode disabled This message appears with an audible alarm and
flashing alarm indicators to indicate that Skin
Mode has been disabled. Activate Skin Mode.
Low skin temperature
This message appears with an audible alarm and
flashing alarm indicators to indicate that the baby’s
skin temperature being monitored by skin
temperature probe #1 is 1°C (or 0.5°C) below the
skin set temperature. To silence this alarm for 15
min, press the Silence/Reset key. Go to RAP 2.3.
High skin temperature
High skin 1 temperature
This message appears with an audible alarm and
flashing alarm indicators to indicate that the baby’s
skin temperature being monitored by skin
temperature probe #1 is 1°C (or 0.5°C) above the
skin set temperature. To silence this alarm for 15
min, press the Silence/Reset key.
High temperature cut
out
This message appears with an audible alarm and
flashing alarm indicators to indicate that incubator
air temperature has reached approximately
103.1°F (39.5°C) (American and Canadian incuba-
tors only). All other incubators will alarm at
99.5°F (37.5°C) for set temperatures < 99°F
(37°C) and 103.1°F (39.5°C) for set temperatures
> 99°F (37°C).
Page 2 - 18
Isolette® Infant Incubator Service Manual (man223rf)