6 English 2244433
*2244433*
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.7 Service indicator
The product is equipped with a service indicator LED.
3.7.1 Service indicator status
Status Meaning
Service indicator shows. End of service interval – servicing is due.
Service indicator flashes. Have the combihammer repaired by Hilti Service.
3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Combihammer
For details of the rated voltage, current, frequency and input power, please refer to the power tool’s
country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer’s power output must
be at least twice the rated input power shown on the rating plate of the tool. The operating voltage of
the transformer or generator must always be within +5% and -15% of the rated voltage of the tool.
Weight in accordance with EPTA procedure 01
10 kg
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Sound power level (L
WA
)
111 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A)
Emission sound pressure level (L
pA
)
100 dB(A)
Uncertainty for the sound pressure level (K
pA
)
3 dB(A)
Total vibration
Vibration emission value for hammer drilling in concrete (a
h,HD
)
8.3 m/s²
Vibration emission value for chiseling (a
h,Cheq
)
8 m/s²
Uncertainty (K)
1.5 m/s²
To Next Page
Loading...
Need help?
General
