131
Saving Waveform Data
Save operation
Display screen [MEAS] > [WAVE]
22
1
Tap the SINGLE key to acquire
waveforms.
The RUN/STOP key lights up in red.
See “4.3 Recording Waveforms” (p. 102).
2
Tap [SAVE].
If the instrument has not recognized the USB
ash drive, the button will be dimmed so that
you cannot tap it.
3
When [Comment entry] is set to [ON],
use the keyboard window to enter the
comment.
(Up to 40 alphanumeric characters and
symbols)
See “Keyboard window” (p. 22).
Once you accept the comment, the data will be
saved.
The following strings will be added before measured data in the CSV le:
• SAMPLING (sampling frequency)
• POINT (recording length)
• COMMENT (entered comment string)
• You may not be able to save the waveform if it was acquired by pressing the RUN/STOP key.
• For more information about saving BIN les, see “7.9 BIN Saving Format” (p. 142).
• Parameters for which the waveform display is set to OFF will not be saved.
• Waveform data cannot be saved while auto-save operation is in progress.
• Waveform data of voltage, current, and motor analysis option will be saved as a set of the
maximum and minimum data compressed using the peak-to-peak compression.
• A dialog box will be displayed while saving the data. To cancel save operation, tap [Cancel] in the
dialog box.
Saving Data and Managing Files
To Next Page
Loading...
