Synchronizing the System Time in the
Network
104
7.2
SNTP
Basic Configuration
Release
6.0
07/2010
X Configuration SNTP Server
In “Server status” you switch the SNTP server of the device on/
off.
In “Anycast destination address” you enter the IP address to
which the SNTP server of the device sends its SNTP packets
(see table 5).
In “VLAN ID” you specify the VLAN to which the device
periodically sends its SNTP packets.
In “Anycast send interval” you specify the interval at which the
device sends SNTP packets (valid entries: 1 s to 3,600 s, on
delivery: 120 s).
With “Disable Server at local time source” the device disables the
SNTP server function if the source of the time is local (see
Time dialog).
IP destination address Send SNTP packet to
0.0.0.0 Nobody
Unicast address (0.0.0.1 - 223.255.255.254) Unicast address
Multicast address (224.0.0.0 - 239.255.255.254),
especially 224.0.1.1 (NTP address)
Multicast address
255.255.255.255 Broadcast address
Table 5: Destination address classes for SNTP packets
To Next Page
Loading...
Need help?
General
