To Next Page

To Previous Page

Routing Commands 18

4.1.3 arp cachesize

This command configures the ARP cache size.

Format arp cachesize <288-2048>

Mode Global Config

4.1.3.1 no arp cachesize

This command configures the default ARP cache size which is 2048.

Format no arp cachesize

Mode Global Config

4.1.4 arp dynamicrenew

This command enables ARP component to automatically renew ARP entries of type dynamic when

they age out.

Format arp dynamicrenew

Mode Global Config

4.1.4.1 no arp dynamicrenew

This command disables ARP component from automatically renewing ARP entries of type dynamic

when they age out.

Format no arp dynamicrenew

Mode Global Config

4.1.5 arp purge

This command causes the specified IP address to be removed from the ARP cache. Only entries of type

dynamic or gateway are affected by this command.

Format arp purge <ipaddr>

Mode Privileged EXEC

4.1.6 arp resptime

This command configures the ARP request response timeout.

The value for

<seconds> is a valid positive integer, which represents the IP ARP entry response

timeout time in seconds. The range for

<seconds> is between 1-10 seconds.

Default l

Format arp resptime <1-10>

Mode Global Config

4.1.6.1 no arp resptime

This command configures the default ARP request response timeout.

Format no arp resptime

Mode Global Config

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE