To Next Page

To Previous Page

4.6.4 default-information originate (RIP)

This command is used to control the advertisement of default routes.

Format default-information originate

Mode Router RIP Config

4.6.4.1 no default-information originate (RIP)

This command is used to control the advertisement of default routes.

Format no default-information originate

Mode Router RIP Config

4.6.5 default-metric (RIP)

This command is used to set a default for the metric of distributed routes.

Format default-metric <0-15>

Mode Router RIP Config

4.6.5.1 no default-metric (RIP)

This command is used to reset the default metric of distributed routes to its default value.

Format no default-metric

Mode Router RIP Config

4.6.6 distance rip

This command sets the route preference value of RIP in the router. Lower route preference values are

preferred when determining the best route.

Default 15

Format distance rip <1-255>

Mode Router RIP Config

4.6.6.1 no distance rip

This command sets the default route preference value of RIP in the router.

Format no distance rip

Mode Router RIP Config

4.6.7 distribute-list out

This command is used to specify the access list to filter routes received from the source protocol.

Default 0

Format distribute-list <1-199> out {ospf | bgp | static | connected}

Mode Router RIP Config

4.6.7.1 no distribute-list out

This command is used to specify the access list to filter routes received from the source protocol.

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE