To Next Page

To Previous Page

Default Route Advertise The default route.

4.6.15 show ip rip interface brief

This command displays general information for each RIP interface. For this command to display

successful results routing must be enabled per interface (i.e. ip rip).

Format show ip rip interface brief

Modes Privileged EXEC

User EXEC

Interface Valid slot and port number separated by forward slashes.

IP Address The IP source address used by the specified RIP interface.

Send Version The RIP version(s) used when sending updates on the specified interface. The types

are none, RIP-1, RIP-1c, RIP-2.

Receive Version The RIP version(s) allowed when receiving updates from the specified interface.

The types are none, RIP-1, RIP-2, Both

RIP Mode RIP administrative mode of router RIP operation; enable activates, disable de-acti-

vates it.

Link State The mode of the interface (up or down).

4.6.16 show ip rip interface

This command displays information related to a particular RIP interface.

Format show ip rip interface <slot/port>

Modes Privileged EXEC

User EXEC

Interface Valid slot and port number separated by forward slashes. This is a configured value.

IP Address The IP source address used by the specified RIP interface. This is a configured value.

Send version The RIP version(s) used when sending updates on the specified interface. The types

are none, RIP-1, RIP-1c, RIP-2. This is a configured value.

Receive version The RIP version(s) allowed when receiving updates from the specified interface.

The types are none, RIP-1, RIP-2, Both. This is a configured value.

Both RIP Admin Mode RIP administrative mode of router RIP operation; enable activates, disable

de-activates it. This is a configured value.

Link State Indicates whether the RIP interface is up or down. This is a configured value.

Authentication Type The RIP Authentication Type for the specified interface. The types are none,

simple, and encrypt. This is a configured value.

Default Metric A number which represents the metric used for default routes in RIP updates origi-

nated on the specified interface. This is a configured value.

The following information will be invalid if the link state is down.

Bad Packets Received The number of RIP response packets received by the RIP process which

were subsequently discarded for any reason.

Bad Routes Received The number of routes contained in valid RIP packets that were ignored for

any reason.

Updates Sent The number of triggered RIP updates actually sent on this interface.

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE