To Next Page

To Previous Page

5.3.6 traffic-shape

This command specifies the maximum transmission bandwith limit for the interface as a whole. Also

known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so that the

transmission traffic rate is bounded. A value from 0-100 (percentage of link rate) must be specified,

with 0 indicating no traffic shaping is in effect. When interface shaping is enabled on a port which has

some queues in WRR group, then the minimum bandwith configuration of the weighted queues is not

honored.

Format traffic-shape <bw>

Modes Global Config

Interface Config

5.3.6.1 no traffic-shape

This command disables the traffic shaping.

Format no traffic-shape

Modes Global Config

Interface Config

5.3.7 show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes.

Format show classofservice dot1p-mapping

Mode Privileged EXEC

The following information is repeated for each user priority.

User Priority The 802.1p user priority value.

Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.

5.3.8 show classofservice trust

This command displays the current trust mode for the specified interface. The slot/port parameter is

optional. If specified, the trust mode of the interface is displayed. If omitted, the most recent global

configuration settings are displayed

Format show classofservice trust [slot/port]

Mode Privileged EXEC

Class of Service Trust Mode The current trust mode: Dot1p, IP DSCP, or Untrusted.

Untrusted Traffic Class The traffic class used for all untrusted traffic. This is only displayed

when the COS trust mode is set to 'untrusted'.

5.3.9 show interfaces cos-queue

This command displays the class-of-service queue configuration for the specified interface. The slot/

port parameter is optional. If specified, the class-of-service queue configuration of the interface is

displayed. If omitted, the most recent global configuration settings are displayed.

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE