Routing Commands 34
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
4.5.11 show ip vrrp
This command displays whether VRRP functionality is enabled or disabled on the switch. It also
displays some global parameters which are required for monitoring This command takes no options.
Format show ip vrrp
Modes Privileged EXEC
User EXEC
Admin Mode Displays the administrative mode for VRRP functionality on the switch.
Authentication Trap Represents the administrative mode for VRRP authentication.
New Master Trap Represents the administrative mode of the New Master Trap function.
Router Checksum Errors Represents the total number of VRRP packets received with an invalid
VRRP checksum value.
Router Version Errors Represents the total number of VRRP packets received with Unknown or
unsupported version number.
Router VRID Errors Represents the total number of VRRP packets received with invalid VRID for
this virtual router.
4.5.12 show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual router
configured on a specific interface.
Format show ip vrrp interface <slot/port> <vrID>
Modes Privileged EXEC
User EXEC
IP Address This field represents the configured primary IP Address for the Virtual router.
Secondary IP Addresses This field represents the configured secondary IP Address for the Virtual router.
VMAC address Represents the VMAC address of the specified router.
Authentication type Represents the authentication type for the specific virtual router.
Priority Represents the priority value for the specific virtual router.
Advertisement interval Represents the advertisement interval for the specific virtual router.
Pre-Empt Mode Is the preemption mode configured on the specified virtual router.
Administrative Mode Represents the status (Enable or Disable) of the specific router.
State Represents the state (Master/backup) of the virtual router.
4.5.13 show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This command
takes no options. It displays information about each virtual router.
Format show ip vrrp interface brief
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
VRID Represents the router ID of the virtual router.
To Next Page
Loading...
Need help?
General
