Routing Commands 30
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Modes Privileged EXEC
User EXEC
VLAN ID Is the identifier of the VLAN.
Logical Interface Indicates the logical slot/port associated with the VLAN routing interface.
IP Address Displays the IP Address associated with this VLAN.
Subnet Mask Indicates the subnet mask that is associated with this VLAN.
MAC Address Displays the MAC Address associated with this VLAN.
4.5 Virtual Router Redundancy Protocol (VRRP) Commands
This chapter provides a detailed explanation of the VRRP commands. The commands are divided by
functionality into the following different groups:
z Show commands are used to display switch settings, statistics and other information.
z Configuration Commands are used to configure features and options of the switch. For every con-
figuration command there is a show command that will display the configuration setting.
z Copy commands are used to transfer configuration and informational files to and from the switch.
4.5.1 ip vrrp
This command enables the VRRP protocol on an interface and designates the configured virtual router
IP address as a secondary IP address on an interface. The parameter
<vrID> is the virtual router ID
which has an integer value range from 1 to 255.
Default none
Format ip vrrp <vrID> <ipaddress> [secondary]
Mode Interface Config
4.5.1.1 no ip vrrp
This command disables the VRRP protocol on an interface. This command also removes a virtual router
IP address as a secondary IP address on an interface. The parameter
<vrID> is the virtual router ID
which has an integer value ranges from 1 to 255.
Format no ip vrrp <vrID> <ipaddress> [secondary]
Mode Interface Config
4.5.2 ip vrrp
This command enables the global administrative mode of VRRP in the router. .
Default disabled
Format ip vrrp
Mode Global Config
4.5.2.1 no ip vrrp
This command disables the global administrative mode of VRRP in the router.
Format no ip vrrp
Mode Global Config
To Next Page
Loading...
Need help?
General
