36
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
4.6 Routing Information Protocol (RIP) Commands
This chapter provides a detailed explanation of the RIP commands. The commands are divided by
functionality into the following different groups:
z Show commands are used to display switch settings, statistics and other information.
z Configuration Commands are used to configure features and options of the switch. For every con-
figuration command there is a show command that will display the configuration setting.
z Copy commands are used to transfer configuration and informational files to and from the switch.
4.6.1 enable (RIP)
This command sets the administrative mode of RIP in the router to active.
Default enabled
Format enable
Mode Router RIP Config
4.6.1.1 no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format no enable
Mode Router RIP Config
4.6.2 ip rip
This command enables RIP on a router interface.
Default disabled
Format ip rip
Mode Interface Config
4.6.2.1 no ip rip
This command disables RIP on a router interface.
Format no ip rip
Mode Interface Config
4.6.3 auto-summary
This command enables the RIP auto-summarization mode.
Default disabled
Format auto-summary
Mode Router RIP Config
4.6.3.1 no auto-summary
This command disables the RIP auto-summarization mode.
Format no auto-summary
Mode Router RIP Config