To Next Page

To Previous Page

Routing Commands 27

User EXEC

4.3 Router Discovery Protocol Commands

This chapter provides a detailed explanation of the Router Discovery commands. The commands are

divided by functionality into the following different groups:

z Show commands are used to display switch settings, statistics and other information.

z Configuration Commands are used to configure features and options of the switch. For every con-

figuration command there is a show command that will display the configuration setting.

z Copy commands are used to transfer configuration and informational files to and from the switch.

4.3.1 ip irdp

This command enables Router Discovery on an interface.

Default disabled

Format ip irdp

Mode Interface Config

4.3.1.1 no ip irdp

This command disables Router Discovery on an interface.

Format no ip irdp

Mode Interface Config

4.3.2 ip irdp address

This command configures the address to be used to advertise the router for the interface. The valid

values for ipaddr are 224.0.0.1 and 255.255.255.255.

Default 224.0.0.1

Format ip irdp address <ipaddr>

Mode Interface Config

4.3.2.1 no ip irdp address

This command configures the default address to be used to advertise the router for the interface.

Format no ip irdp address

Mode Interface Config

4.3.3 ip irdp holdtime

This command configures the value, in seconds, of the holdtime field of the router advertisement sent

from this interface. The range is the maxadvertinterval to 9000 seconds.

Default 3 * maxinterval

Format ip irdp holdtime <maxadvertinterval-9000>

Mode Interface Config

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE