39
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Format no ip rip receive version
Mode Interface Config
4.6.10 ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for <
mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version
1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP
version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default rip2
Format ip rip send version {rip1 | rip1c | rip2 | none}
Mode Interface Config
4.6.10.1 no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be sent.
Format no ip rip send version
Mode Interface Config
4.6.11 hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default enabled
Format hostroutesaccept
Mode Router RIP Config
4.6.11.1 no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format no hostroutesaccept
Mode Router RIP Config
4.6.12 split-horizon
This command sets the RIP split horizon mode.
Default simple
Format split-horizon {none | simple | poison}
Mode Router RIP Config
4.6.12.1 no split-horizon
This command sets the default RIP split horizon mode.
Format no split-horizon
Mode Router RIP Config