To Next Page

To Previous Page

Routing Commands 28

4.3.3.1 no ip irdp holdtime

This command configures the default value, in seconds, of the holdtime field of the router

advertisement sent from this interface.

Format no ip irdp holdtime

Mode Interface Config

4.3.4 ip irdp maxadvertinterval

This command configures the maximum time, in seconds, allowed between sending router

advertisements from the interface. The range for maxadvertinterval is 4 to 1800 seconds.

Default 600

Format ip irdp maxadvertinterval <4-1800>

Mode Interface Config

4.3.4.1 no ip irdp maxadvertinterval

This command configures the default maximum time, in seconds.

Format no ip irdp maxadvertinterval

Mode Interface Config

4.3.5 ip irdp minadvertinterval

This command configures the minimum time, in seconds, allowed between sending router

advertisements from the interface. The range for minadvertinterval is three to the value of

maxadvertinterval.

Default 0.75 * maxadvertinterval

Format ip irdp minadvertinterval <3-maxadvertinterval>

Mode Interface Config

4.3.5.1 no ip irdp minadvertinterval

This command sets the default minimum time to the default.

Format no ip irdp minadvertinterval

Mode Interface Config

4.3.6 ip irdp preference

This command configures the preferability of the address as a default router address, relative to other

router addresses on the same subnet. The range is -2147483648 to -1 to 0 to 1 to 2147483647.

Default 0

Format ip irdp preference <-2147483648-2147483647>

Mode Interface Config

4.3.6.1 no ip irdp preference

This command configures the default preferability of the address as a default router address, relative to

other router addresses on the same subnet.

Hirschmann PowerMICE Reference Manual

Other manuals for Hirschmann PowerMICE