EasyManuals Logo

Hirschmann PowerMICE Reference Manual

Hirschmann PowerMICE
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Quality of Service (QoS) Commands 44
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
5.1.2 mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The <oldname> parameter is
the name of an existing MAC ACL. The <
newname> parameter is a case-sensitive alphanumeric string
from 1 to 31 characters uniquely identifying the MAC access list.
This command fails if a MAC ACL by the name <
newname> already exists.
Format mac access-list extended rename <oldname> <newname>
Mode Global Config
5.1.3 {deny|permit}
This command creates a new rule for the current MAC access list. Each rule is appended to the list of
configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules within a MAC ACL
cannot be deleted individually. Rather, the entire MAC ACL must be deleted and re-
specified.
Note: An implicit 'deny all' MAC rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a minimum,
the source and destination MAC value must be specified, each of which may be substituted using the
keyword any to indicate a match on any value in that field. The bpdu keyword may be specified for the
destination MAC value indicating a well-known BPDU MAC value of 01-80-c2-xx-xx-xx (hex), where
'xx' indicates a don't care. The remaining command parameters are all optional, but the most frequently
used parameters appear in the same relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from 0x0600-
0xFFFF. The currently supported <
ethertypekey> values are: appletalk, arp, ibmsna, ipv4, ipv6,
ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its equivalent
Ethertype value(s).
Table 7. Ethertype Keyword and 4-digit Hexadecimal Value
Ethertype Keyword Corresponding Value
appletalk 0x809B
arp 0x0806
ibmsna 0x80D5
ipv4 0x0800
ipv6 0x86DD
ipx 0x8037
mplsmcast 0x8848
mplsucast 0x8847
netbios 0x8191
novell 0x8137, 0x8138
pppoe 0x8863, 0x8864
rarp 0x8035

Other manuals for Hirschmann PowerMICE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hirschmann PowerMICE and is the answer not in the manual?

Hirschmann PowerMICE Specifications

General IconGeneral
BrandHirschmann
ModelPowerMICE
CategoryNetwork Router
LanguageEnglish

Related product manuals