Hirschmann PowerMICE Reference Manual

Quality of Service (QoS) Commands 47
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
The source layer 4 port match condition for the IP ACL rule is specified by the port value parameter.
The range of values is from 0 to 65535.
The <
portvalue> parameter uses a single keyword notation and currently has the values of domain,
echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp
, and www. Each of these values
translates into its equivalent port number, which is used as both the start and end of a port range.
The command specifies a destination ipaddress and destination mask for match condition of the IP ACL
rule specified by the dstip and dstmask parameters.
The command specifies the TOS for an IP ACL rule depending on a match of precedence or DSCP
values using the parameters dscp, precedence, tos/tosmask.
The assign-queue parameter allows specification of a particular 802.1p user priority for traffic that
matches this rule. The allowed
<queue-id> value is 0-7. The matching traffic is transmitted with the
modified 802.1p user priority.
The command specifies the redirect interface which is the slot/port to which packets matching this rule
are forwarded.
Default none
(IP Standard ACL)
Format access-list <1-99> {deny | permit} <srcip> <srcmask> [assign-
queue <queue-id>] [redirect <slot/port>]
Mode Global Config
(IP Extended ACL)
Format access-list <100-199> {deny | permit} {every | {{icmp | igmp |
ip | tcp | udp | <number>} <srcip> <srcmask>[{eq {<portkey> |
<portvalue>}] <dstip> <dstmask> [{eq {<portkey>| <portvalue>}]
[precedence <precedence> | tos <tos> <tosmask> | dscp <dscp>]
[assign-queue <queue-id>] [redirect <slot/port>]}}
Mode Global Config
5.2.1.1 no access-list
This command deletes an IP ACL that is identified by the parameter <accesslistnumber> from the
system
.
Format no access-list <accesslistnumber>
Mode Global Config
5.2.2 ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access list relative to
other IP access lists already assigned to this interface. A lower number indicates higher precedence
order. If a sequence number is already in use for this interface, the specified access list replaces the
currently attached IP access list using that sequence number. If the sequence number is not specified for
this command, a sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used.
Default none

Hirschmann PowerMICE Specifications

General

Brand	Hirschmann
Model	PowerMICE
Category	Network Router
Language	English