Installation SPIDER PL
Release
08
09/2018
31
4.3 Grounding the device
Prerequisite:
Use a wire diameter for the ground conductor that is no smaller than the
diameter of the supply voltage connection, however of at least 0.5 mm²
(AWG20).
Proceed as follows:
Ground the device via the ground screw.
The grounding screw is located on the topside as shown in the illustration.
4.4 Installing an SFP transceiver (optional)
Prerequisites:
Exclusively use Hirschmann SFP transceivers.
See “Accessories” on page 57.
Figure 1: Installing SFP transceivers: Installation sequence
1
2
3
To Next Page
Loading...
