4.1.1.8 inspect and maintain the direction machine parts
1、Inspect the drive of the gear whether agile.
If it is not agile, dismantle the direction machine to
see the gear and rack whether have wear,instead the
parts according to the inspection.
2 、 Whether the inspection gear drive reverse gap does
surpass the rating
If it does,adjust the gap and the bolt .
If cannot reduce the gap through the adjustment, instead
the gear, rack
3、Inspects the dustproof rubber set whether gets older and
dehiscence.Replace the olde rand dehiscence rubber wrap
4、Inspect the tow balls on the steering tension rod
whether rotates nimbly with no loose. If it is not,
replace the ball.
5、Inspects the dustproof rubber set of the ball whether
gets older and dehiscence.Replace the olde rand
dehiscence rubber wrap.
6、Inspect the steering tension rod whether have crack and
distortion.If it does, through the sizing repair
Warnning: Do not use the welding to repair the steering
tension rod.
To Next Page
Loading...
