crack, in which case it must be replaced.
Attention,1.The standard thickness of the front disk
brake plate is 4mm. Brake shoe must be
replaced when the thickness is less than
3.5mm.
2.Replace the brake shoe when it is
distortion and crack.
Attention:1The standard thickness of disk brake plate
is 7.5mm.Disk brake plate must be
replaced when the thickness is less than
6.8MM.
2.Replace the disk brake plate when it is
distortion and crack.
4.2.2.4 Assembly of front Brake System
Use two nylon tape connect the the fuel pipe clip with both left
and right higher front shaft arms.
Attention: Fuel Pipe must avoid physical
contact with other components in movement.
Fix the Disk Brake Plate onto the Front Wheel Hub with four
pieces of M Bolts.
To Next Page
Loading...
