1. INTRODUCTION TO HF-W100E/IoT
1-4
1.2.3 BIOS settings
The factory default BIOS settings for HF-W100E/IoT are as follows. Do not change these
settings. If you do, it may affect the processing of realtime control.
BIOS settings other than those below are the same as the default settings for the HF-W100E.
For details about the setup menu, refer to “5.3 BIOS Setup” in the HF-W instruction
manual.
Setting item Value Caution
Do not change these settings.
[Caution]
If you use Restore Defaults for Windows 7 (in the case of Windows® Embedded Standard 7)
or Restore Defaults for Windows 10 (in the case of Windows® 10) in the setup menu, the
BIOS settings go back to the initial settings of the HF-W100E. After you use this menu, restore
the BIOS settings to the factory default settings of HF-W/IoT (as in the above table).
To Next Page
Loading...
