Hitachi HF-W100E/IoT - Changes to the HF-W Instruction Manual; Time Required for Restoring the Factory Condition with the Recovery DVD; Recovery DVD Name

1. INTRODUCTION TO HF-W100E/IoT
1-5
1.3 Changes to the HF-W Instruction Manual
This section explains the changes you must make to the HF-W instruction manual.
1.3.1 Time required for restoring the factory condition with the recovery DVD
In “7.1 Overview of Restoration Procedure” in the HF-W instruction manual, the time
required for restoring the factory condition is approximately 30 minutes for HF-W100E/IoT.
1.3.2 Recovery DVD name
The name of the recovery DVD described in “7.2 Preparation” and “7.3 Restoring the
System Drive Back to the Factory-Shipped Condition” in the HF-W instruction manual must
be replaced as follows.
<Name to replace>
Before
HITACHI HJ-100E-**** Product Recovery DVD
(The underlined part is the model number of the device you
purchased.)
After
HITACHI HF-W/IoT HJ-100E-**** Product Recovery DVD
(The underlined part is the model number of the device you
purchased.)