Hitachi VSP F1500

CL7-B FIBRE ELUN AUT DA N FCAL N 0 64539 50060e8006fc1b61
CL8-A FIBRE TAR AUT D4 N FCAL N 0 64539 50060e8006fc1b70
CL8-B FIBRE TAR AUT CE N FCAL N 0 64539 50060e8006fc1b71
C:\HORCM\etc>raidcom -zt 4_no_port.bat -load portcnf_27.dat -checkmode precheck
C:\HORCM\etc>raidcom add path -path_grp 1 -port CL1-C -external_wwn
50060e80,06fc4180
raidcom: PORT(2) does not exist as status is [2] on UnitID# 0.
raidcom_#2 : [EX_CTXCHK] Context Check error
C:\HORCM\etc>raidcom add path -path_grp 1 -port CL1-D -external_wwn
50060e80,06fc4190
raidcom: PORT(3) does not exist as status is [2] on UnitID# 0.
raidcom_#3 : [EX_CTXCHK] Context Check error
C:\HORCM\etc>raidcom add path -path_grp 1 -port CL1-E -external_wwn
50060e80,06fc41a0
raidcom: PORT(4) does not exist as status is [2] on UnitID# 0.
raidcom_#4 : [EX_CTXCHK] Context Check error
Host group check
The check is performed from the following perspective. Note that checking for
an attribute of host group, or for a name of host group is not executed.
Check with the attribute setting
Checks whether the operation is performed for an existing host group. If the
host group does not exist, an error is detected.
If it is not clear whether the target port or host group exists (if the target
port or host group information does not exist in the configuration definition
file), the error is not detected.
The commands as the target of the check are shown below.
• raidcom modify host_grp -port <port#> [<host group name>] -
host_mode <host mode> [-host_mode_opt <host mode option> … ]
• raidcom add hba_wwn -port <port#> [<host group name>] -hba_wwn
<WWN strings>
• raidcom delete hba_wwn -port <port#> [<host group name>] -hba_wwn
<WWN strings>
• raidcom set hba_wwn -port <port#> [<host group name>] -hba_wwn
<WWN strings> -wwn_nickname <WWN Nickname>
• raidcom reset hba_wwn -port <port#> [<host group name>] -hba_wwn
<WWN strings>
• raidcom add lun -port <port#> [<host group name>] {-ldev_id <ldev#>
[-lun_id<lun#>] | -grp_opt <group option> -device_grp_name <device
group name> [<device name>]}
• raidcom delete lun -port <port#> [<host group name>] {-lun_id <lun#>
| -ldev_id <ldev#> | -grp_opt <group option> -device_grp_name
<device group name> [<device name>]}
3-32
CCI functions
Command Control Interface User and Reference Guide