¢
horctakeover, paircurchk, paircreate, pairsplit, pairresync,
pairvolchk, pairevtwait, pairsyncwait
¢
raidscan (except -find verify, -find inst), raidar, pairdisplay
¢
raidvchkset, raidvchkscan (except -v jnl), raidvchkdsp
[EX_ESPERM] Permission denied with the SLPR
[Cause ] : A specified command device does not have a
permission to access other SLPR.
[Action] : Please make the SLPR so that the target port and
the command device belongs to the same SLPR.
SLPR configuration examples
Single host
Figure 8-7 SLPR configuration on a single host on page 8-18 provides an
example of when control is denied to the paircreate and raidscan
commands in the following cases:
• The volume described on RMINST1 is different from the SLPR of the
command device, so the paircreate command cannot control the paired
volume.
• The specified port is different from the SLPR of the command device, so
the raidscan -p CL3-A command cannot scan any ports that are defined
as SLPR#N.
Figure 8-7 SLPR configuration on a single host
To operate SLPR#N, assign the command device. If RMINST1 has been
assigned to a command device for SLPR#N, the paircreate command is
permitted. However, the raidscan -p CL3-A command (via RMINST0) is
unable to scan a port, because the specified port is different than the SLPR of
the command device. In this case, -p CL3-A must be operated via RMINST1,
as shown in the following example.
8-18
Examples of using CCI commands
Command Control Interface User and Reference Guide
To Next Page
Loading...
