ShadowImage. Therefore, CCI supports saving/restoring the GUID DiskId of
the GPT Basic disk to the inqraid command.
• gvinfex option (Windows 2012 only)
This option retrieves the LUN signature and volume layout information by
way of a raw device file provided via STDIN or arguments, and saves it in
a system disk file with the following format:
\WindowsDirectory\VOLssss_llll.ini
where
ssss = serial#
llll = LDEV#
Normally, this option is used to save the Disk signature/GUID DiskId and
volume layout information once, after it has been written on a potential
(and before its paircreate). You do not need to directly view these host
files.
For example, saves the volume information for all physical drives:
D:\HORCM\etc>inqraid $Phys -gvinfex -CLI
\\.\PhysicalDrive10:
# Harddisk10 -> [VOL61459_448_DA7C0D91] [OPEN-V ]
\\.\PhysicalDrive11:
# Harddisk11 -> [VOL61459_449_D4CB5F17-2ADC-4FEE-8650
D3628379E8F5] [OPEN-V ]
\\.\PhysicalDrive12:
# Harddisk12 -> [VOL61459_450_9ABDCB73-3BA1-4048-9E94
22E3798C3B61] [OPEN-V ]
• -svinfex[=PTN] option (Windows 2003 only)
This option writes LUN signature/GUID DiskId and volume layout
information (that had previously been saved in a system disk file) by way
of a raw device file provided via STDIN or arguments.
This option gets the serial# and LDEV# of the RAID storage system for
the target device using SCSI Inquiry, and writes the signature/GUID
DiskId and volume layout information from the VOLssss_llll.ini file to
the target device.
This option will work correctly (even if Harddisk# changes due to
configuration changes) because the signature/GUID DiskId and volume
layout information is associated the array serial# and LDEV# (not
Harddisk#).
• [=PTN]
This option specifies a string pattern usable to select only the pertinent
output lines being provide from STDIN. If used as shown, only the
pairdisplay output lines containing Harddisk would be used to cause
signature writing.
D:\HORCM\etc>pairdisplay -l -fd -g URA | inqraid -
svinfex=Harddisk
[VOL61459_448_DA7C0D91] -> Harddisk10 [OPEN-V ]
[VOL61459_449_D4CB5F17-2ADC-4FEE-8650-D3628379E8F5] ->
Harddisk11 [OPEN-V ]
[VOL61459_450_9ABDCB73-3BA1-4048-9E94-22E3798C3B61] ->
Harddisk12 [OPEN-V ]
• -gplbaex option (Windows 2012/2008 Only)
Examples of using CCI commands
8-11
Command Control Interface User and Reference Guide
To Next Page
Loading...
