Hitachi VSP F1500

Table 9-1 System log messages
Message ID Condition Cause Recommended action
HORCM_001 The HORCM log file
cannot be opened.
The file cannot be created
in the HORCM directory.
Create space on the disk on
which the root directory resides.
HORCM_002 The HORCM trace file
cannot be opened.
The file cannot be created
in the HORCM directory.
Create space on the disk on
which the root directory resides.
HORCM_003 The HORCM daemon
process cannot create
a child process due to
an error.
HORCM daemon attempted
to create more processes
than the maximum
allowable number.
Terminate unnecessary programs
or daemon processes running
simultaneously.
HORCM_004 HORCM assertion
failed, resulting in a
fatal internal error in
the HORCM.
An internal error that could
not be identified by the
HORCM occurred.
Restart the system, and contact
Hitachi Data Systems customer
support.
HORCM_005 The CCI software
failed to create the end
point for remote
communication.
HORCM failed to create a
socket, or an error exists in
the format or a parameter
in the HORCM
configuration definition file
($HORCM_CONF).
Refer to the HORCM startup log
to identify the cause of the error.
HORCM_006 HORCM memory
allocation failed.
HORCM memory could not
be secured.
Increase the system virtual
memory, or close any
unnecessary programs.
HORCM_007 An error exists in the
parameter value in the
HORCM setup file.
An error exists in the
parameter value setting in
the HORCM setup file.
Refer to the startup log and reset
the parameters.
HORCM_008 HORCM configuration
definition file
parameters reading
fails.
An error exists in the
format or parameters of
the HORCM configuration
definition file
($HORCM_CONF).
Refer to the HORCM startup log
to identify the cause of the error.
HORCM_009 TrueCopy/
ShadowImage
connection to the CCI
software failed.
System devices are
improperly connected, or
an error exists in the
device parameter in the
HORCM configuration
definition file.
Refer to the HORCM startup log
to identify the cause of the error.
HORCM_101 TrueCopy/
ShadowImage and the
CCI software
communication fails.
A system I/O error
occurred or an error exists
in the device parameter in
the HORCM configuration
definition file
($HORCM_CONF).
Refer to the HORCM startup log
to identify the cause of the error.
HORCM_102 The volume is
suspended.
The pair status was
suspended due to code
XXXX.
Contact Hitachi Data Systems
customer support.
HORCM_103 Detected a validation
check error on this
volume (xxxx
unit#x,ldev#x):
A validation error occurs on
the database volume, or
validation parameters for
this volume are illegal.
Please confirm the following
items, and use raidvchkdsp -v
Troubleshooting
9-7
Command Control Interface User and Reference Guide