Hitachi VSP F1500

HORCM_CMD
#dev_name dev_name dev_name
\\.\CMD-30095-250-CL1-A
• Minimum specification
For the command device with serial number 30095, specify as follows:
\\.\CMD-30095
• Command devices in the multi-path environment
Specify serial number 30095, and LDEV number 250 as follows:
\\.\CMD-30095-250
• Other specifications
Specify serial number 30095, LDEV number 250, and port number CLI-A
as follows:
\\.\CMD-30095-250-CL1-A
or
\\.\CMD-30095-250-CL1
For UNIX
Device files are specified for command devices in UNIX. However, CCI
provides a method that is not affected by changes of device files in UNIX by
using the following naming format specifying the serial number, LDEV
number, and port number in that order:
\\.\CMD-Ser#-ldev#-Port#:HINT
Note: For VSP G1000, G1500, and VSP F1500, add a "3" to the beginning of
the serial number (for example, enter "312345" for serial number "12345").
The following example specifies 30095 for the storage system's serial
number, 250 for the LDEV number, and CL1-A for the port number:
HORCM_CMD
#dev_name dev_name dev_name
\\.\CMD-30095-250-CL1-A:/dev/rdsk/
HINT provides a path to scan and specifies a directory ending with a slash (/)
or a name pattern including the directory. Device files are searched via a
name filter similar to the inqraid command.
• To find command devices from /dev/rdsk/, enter: ' /dev/rdsk/*
• To find command devices from /dev/rdsk/c10, enter: ' /dev/rdsk/c10*
• To find command devices from /dev/rhdisk, enter: ' /dev/rhdisk*
For a command device alternative configuration , HINT of the second
command device can be omitted. In this case, command devices are
searched from the device file that was scanned first.
HORCM_CMD
#dev_name dev_name dev_name
\\.\ CMD-30095-CL1:/dev/rdsk/ \\.\ CMD-30095-CL2
• Minimum specification
For the command device of a storage system with serial number 30095,
specify as follows:
2-20
CCI software environment
Command Control Interface User and Reference Guide