BASE STATION SETTINGS
45
6. Data port – This port is used for sending HME-
supported commands to the base over a TCP/IC
socket. The port value is 3255, or it can be set at 0 to
disable the port.
To edit the data port number, use the ◄ and ►
buttons to move the highlighted box, and then use
the + and − buttons to change the number in the
highlighted box.
7. Telnet port – This port is reserved for use by HME
Technical Support.
Press the More button on the ADVANCED NETWORK
SETTINGS display to access the BOOTLOADER
NETWORK INFO display.
If instructed by HME Technical Support to edit the
Telnet port number, use the ◄ and ► buttons to
move the highlighted box, and then use the + and −
buttons to change the number in the highlighted box.
Bootloader information is used by HME Technical
Support.
To Next Page
Loading...