152
Step 2
Insert Wrench to Hold Thru-Shaft
Insert the 3/4” (19mm) open end wrench through the slot in the base of the thru-shaft motor. The
slot is located between the hog head chassis and the spray head. Figure 3 and 4.
Step 1
Remove the High Pressure Hose
Remove the high pressure hose from the top of the thru-shaft motor by turning the hand nut at the
base of the hose counterclockwise. If the hand nut is too tight to turn by hand, use the channel lock
pliers to free it, then continue loosening it by hand. Figure 1 and 2.
Slot for 3/4” End
Wrench
Hog Head Chassis
Spray Head
3/4” Open End Wrench
Pressure Hose
Figure 2: High pressure hose removed
Figure 1: High pressure hose on top of the thru-shaft motor
Figure 3: Thru-shaft motor on work bench showing position
of slot and 3/4” open end wrench.
Figure 4: Location of slot in thru-shaft motor mounted on hog
head for 3/4” open end wrench.
To Next Page
Loading...
Need help?
General