158
Step 9
Install The Thrust Housing Cap.
Inspect the O-ring seal in the thrust housing cap. Replace the O-ring if it shows any sign of nicks,
cuts, deterioration or wear. Then apply light layer of grease to the O-Ring. The grease will help the
cap assembly slide into the torque housing and reduce the possibility for the O-ring to be pushed out
of the seat or damaged as the assembly is installed. Figure 15.
Set the thrust housing cap on top of the thrust housing and carefully press it into the housing. Align
the bolt holes in the cap to the threaded holes in the thrust housing. Apply Anti-seize to the 3/8”
Allen bolts and hand tighten using a crisscross pattern. Use the 6 mm Allen wrench to tighten the
thrust housing cap bolts to “snug” using a crisscross pattern. Figure 16.
1
2
3
4
5
6
Figure 15: Inspect and grease the O-ring seal on the thrust
housing cap.
Figure 16: Apply anti-seize to the thrust housing bolts and
tighten them in a crisscross pattern to snug
using a 6 mm Allen wrench.
To Next Page
Loading...
Need help?
General