TROUBLESHOOTING
Imager Duo Operator’s Manual
6.7
User Assisted Recovery Option
Click on the
Begin User Assisted Recovery
button. The system will return
slides to their original locations and enter idle mode. This process will take a
couple of minutes from the time the
Recovery
button is clicked.
When the system has recovered, the doors will unlock and the display will
show the slide cassettes colored blue or gray, as they were at the time of the
error condition. At this point the operator may do one of the following:
• Begin processing by clicking on the green GO button. The system will
start processing at the point where it left off.
• Remove completed slide cassettes (all blue) and replace with unpro-
cessed cassettes. Do NOT remove partially completed cassettes. Leave
them in place to be processed to completion.
Note:
The batch was terminated at the time of the error. The Run Report (refer
to Run Report in Chapter 4) will list any completed cassettes as a com-
pleted batch.
Note:
If the recovery is not successful, a User Assessment window with a
Shutdown System
button will appear.
To Next Page
Loading...
