IMAGER DUO SYSTEM INSTALLATION
Imager Duo Operator’s Manual
2.1
Chapter Two
Imager Duo System Installation
WARNING
Service Installation
Only
GENERAL
The ThinPrep
®
Imager Duo System and peripherals must be installed by
Hologic Service Personnel. When installation is complete, the Service personnel
trains the operator(s), using the Operator’s Manual as the training guide.
In the event the equipment must be moved after installation, please contact
Hologic Technical Support. (Refer to Service Information, Chapter 8.)
ACTION UPON DELIVERY
Remove and read the
Operating Instructions Prior to Installation
sheet attached to
the packing carton.
Inspect the packing cartons for damage. Report any damage immediately to the
shipper and/or Hologic Service as soon as possible. (Refer to Service Informa-
tion, Chapter 8.)
Leave the equipment in the packing cartons for Hologic Service installation.
Store the equipment in a suitable environment until installation (cool, dry,
vibration-free area).
PREPARATION PRIOR TO INSTALLATION
Pre-Installation Site Assessment
A pre-installation site assessment is performed by Hologic Service Personnel.
Be sure to have prepared any and all site configuration requirements as
instructed by the Service personnel.
To Next Page
Loading...
