BF15DmBF20D
9)
Hold the flywheel using the commercially available fly-
wheel holder and tighten the flywheel nut.
TORQUE:
132
N*m
(13.5
kgf*m,
98
Ibf*ft)
10) Remove the flywheel holder. Install the starter pulley and
tighten the three
6
x
12 mm flange bolts.
TORQUE:
11
N*m
(1.1
kgf*m,
8
Ibfaft)
removal.
-
starter case
6
(P.
7-10).
-
recoil starter
(P.
7-9).
-
neutral start cable
(P.
7-1).
-
left and right engine under covers
(P.
5-2 and
3).
-
engine cover.
1l)lnstall the following removed parts in the reverse order
of
2.
TIMING BELTlPULLEYS
a.
REMOVAL
1) Remove the following:
-
engine cover
(P.
5-1).
-
left engine under cover
(P.
5-2).
-
right engine under cover
(P.
5-3).
-
recoil starter
(P.
7-2)
2) If it is necessary
to
remove the timing belt driven pulley,
3)
Remove the flywheel and coils
(P.
9-2).
4)
Turn the crankshaft clockwise using the Crankshaft holder
(as the arrow marked direction) until the
“I”
#l timing
mark on the timing belt driven pulley aligns with the
“+T”
mark on the cylinder head.
loosen the timing belt driven pulley mounting bolt.
5) Remove the timing belt from the timing belt driven pulley
first, then remove the timing belt from the timing belt drive
pulley.
I
[l] FLYWHEEL NUT
”
’
’
[2] FLYWHEEL HOLDER
(Commercially available)
STARTER
[3] CRANKSHAFT
~~
HOLDER
1
07923-ZA00100
[2] TMARK’
DRIVE PULLEY DRIVEN PULLEY
9-8
To Next Page
Loading...
