TUXEDOW INSTALLATION AND SETUP GUIDE
11
SECURITY MENU
Introduction to Security System Operation
You can arm the system in one of three arming modes: Away, Stay, and Night. The following table lists the three different
arming modes and the results of each.
FEATURES FOR EACH ARMING MODE
Touch to arm when no one is staying
on the premises. When armed in
AWAY, the system sounds an alarm if
a protected door or window is opened,
or if any movement is detected inside
the premises.
Yes Yes Yes Yes
Touch to arm when you are staying
home but might expect someone to
use the entrance door later.
When armed in STAY, the system
sounds an alarm if a protected door or
window is opened, but you may
otherwise move freely throughout the
premises.
Yes Yes Yes No
Touch to arm when you are staying
home and do not expect anyone to use
the entrance door.
Yes
Yes (set for Away or
Stay Mode)
No (set for Instant or
Maximum Mode)
Away or
Maximum
Mode)
No (set for Stay
or Instant
Mode)
See Night Mode
NOTE: Night Mode (on Residential Panels Only) arms all perimeter zones plus all zones listed in Zone List 5.
IMPORTANT: On Commercial systems, “Away Auto Stay” mode is shown as “Away” mode (with all zones monitored).
However, some interior zones may not be armed.
NOTE
The Voice Status Sounder Icon ( ) indicates the Voice feature. Touch the Voice Status Sounder Icon to hear system
status. Wait 3 seconds and touch again to hear Zone Faults or Trouble conditions. Voice status will annunciate even if Voice
mode and Chime mode are disabled. Note that the Voice feature must be enabled for this icon to function correctly during an
alarm condition.
To Next Page
Loading...
Need help?
General
