TUXEDOW INSTALLATION AND SETUP GUIDE
25
Device Events
1. From the Home screen, touch the Setup, System Setup and
CS Setup icons.
2. Enter Authorized Installer Code.
3. Touch the Device Events icon.
4. To reset, or clear, the events touch the X in the bottom right
hand corner of the screen.
The Device Events screen displays the
system events of the keypad only (resets,
time set, end user license accepted,
response types, etc.)
This is not the event log of the control
panel.
Code Authority
1. From the Home screen, touch the Setup, System Setup and
CS Setup icons.
2. Enter Authorized Installer Code.
3. Touch the Code Authority icon.
4. Enter the 4-digit code.
5. Touch to go back to the CS Setup Screen or to exit.
A four-digit code can be entered to learn
the user name and Authority level of that
code.
Panel Config
1. From the Home screen, touch the Setup, System Setup and
CS Setup icons.
2. Enter Authorized Installer Code.
3. Touch the Panel Configuration icon to display the Panel
Hardware version, Panel Revision, Number of zones, Number
of Partitions, Home Partition, Cal Support, and Sequence.
4. Touch the X to delete the panel configuration (the
Touchscreen resets and the panel configuration is
downloaded from the panel into the Touchscreen.) or touch
to go back to the CS Setup Screen or
to exit.
A "Panel Configuration" screen is displayed
providing details of your system.
Touching Delete prompts you with a
confirmation screen displaying:
Are you sure you want to delete Panel
Configuration? OK Cancel.
If you touch OK, the TUXEDOW deletes
the configuration of the control, the
TUXEDOW reboots, and re-searches for
the installed control. Then, it downloads
the configuration again.
To Next Page
Loading...
Need help?
General
