How to Change User Codes
User Guide
Changing Codes Using User 1
You should change your code regularly to prevent potential intruders from knowing your code. All
codes are 4-digits.
The
factory set code
is
[0][1][2][3]. User code I can only
be
changed
by
user
1.
To change user code:
LCD
Keypad:
o then [0][1][2][3]
Press
0 and then enter your code [0][1][2][3].
The
iil
I
LED goes
off
to indicate that you are in Programming
lo>walk
Test
mode. The first menu
Walk
Test
appears on the screen.
Press
[8]
on the keypad to enter User Set-Up.
8>Set
Up
User
[Number]
Press
[1]
or
[2] on the keypad to edit the required user.
[1]
or
[2]
Enter the new [ 4-digit code].
If
the code is accepted the
system produces a double beep.
If
it is rejected the code
may
already
be
in use and the system produce a long tone.
You must choose a different 4-digit code.
[
4-digit
code]
I
Upon the last keypress the code
is
saved.
I
Code
Saved
I
Press ® twice to exit Programming mode.
The
iil
®
LED
comes on and the screen displays the date
and
time.
I
Sunday
01-Jan
14:10
I
.
LED
Keypad:
o then [0][1][2][3]
Press 0 and then enter your code [0][1][2][3].
The./
LED comes on and the
iil
LED goes
off
to indicate that you
are in Programming mode.
12345678
©©©©©©©©
--"'~--©sos
(J
@
@
.....
I
©Iil
Press [8]
on
the keypad. LEDs 1 and 2 are
on
to
indicate
[y]
that you have two options, user I and user 2.
12345678
@@©©©©©© (J @
--'_--@$O$
Press [1]
or
[2] on the keypad to edit the required user.
@
.....
LEDs 1-4 are on.
©Iil
Enter the
new
[4-digit code].
If
the code is accepted the
system produces a double beep.
If
it
is
rejected the code
may already
be
in use
and
the system produces a long tone.
You
must
choose a different 4-digit code.
Upon the last keypress the code is saved. LEDs 1-4 are off.
Press
® twice to exit Programming mode.
The
iil LED
comes on
and
the
./
goes off.
10
[1]
or
[2]
then [4-digit code]
I
To Next Page
Loading...
Need help?
General
