12345678
@@@@@@@@
(I
@
--_--@sos
@ ....
@1iJ
User Guide
How
to
Test
the
Alarm
System
2 =
LED
Keypad:
The LED keypad is limited to show the last eight set periods with the eighth being the oldest. Zone,
sos
and../'
LEOs are on, to show zone in alann . A flashing LED indicates the first zone in alann.
00
indicates the status
of
the panel at the time
of
the alann.
Press CD and then enter your code [0][1][2][3]. The
00
LED goes
CD
then [Q][I][2][3]
off
and
the../'
LED comes on to indicate that you are in
I
Programming mode.
Press
® to enter into Event Log menu. LEOs 1 and 2 are on.
Press
[2] for LED keypad. The first zone to activate is indicated
cr
by a flashing LED.
I
Press
[1
to
8]
for the desired event
or
® to go through
events
in
sequence.
Press CD twice to leave
the
menu.
How to Test Your Alarm system
You should check that your alann system still works correctly by periodically carrying out the alann
system tests described here.
How
to Test the Bell, Strobe and Internal Sounder
This function tests the alann function
of
the Bell, Strobe or Internal Sounder. Pressing the appropriate
key.
[1-3] toggle the function ON
or
OFF. Using the ® also selects the appropriate alann function.
Pressing [0] turns all alann outputs to OFF.
Pressing
(l)
toggles the selected
alann
output.
Pressing CD turns
off
all outputs and leaves the function.
The outputs are:
1 = Bell, 2 = Strobe, 3 = Sounder
NOTE:
To test the Low volume sounder enable option 3 only. To test for a high volume sounder
enable both options 2 and 3 together.
16
To Next Page
Loading...
