How to Quick Set
User Guide
LED Keypad:
Enter your [4-digit code] to start the exit procedure (for
more information see How to
Set the System).
Press 8 and the exit beep tone stops, and all LEOs for used
zones that can be omitted come on.
Press the zone [number] to be omitted. The LED now flashes to
show the zone as omitted.
If
a flat reject tone is heard, then the
zone cannot be omitted.
Press
Q)
or allow the system to set.
How to Quick Set the System
When you set the system you usually have about
30
seconds to exit the premises. This also means
that you need to wait 30 seconds for the system to set. You can reduce this time to
just
five seconds
by
carrying out a
Quick
Set.
Enter your [4-digit code] to start the exit procedure. The exit beep tone starts.
(For more information see
How
to
Set
the
System).
Press
Q)
to Quick Set the system and the exit beep tone changes to a more rapid tone.
The system sets in five seconds, and the exit tone stops.
Single Key Setting
If
enabled by the engineer, the setting process can be started by pressing Set, rather than entering a user
8
To Next Page
Loading...
Need help?
General
