How to Part Set
User
Guide
How to Part Set the System
If
your installer has programmed your system for part
set
operation you can set certain zones
of
the
system while others remain unset. Part set operation is often used at night time, and it permits you to
freely walk around the bedrooms while the living area and outside doors are protected. Your system
may have 2 part-set programs called Program 2 and Program 3.
Before part-setting the system you should ensure that all doors and windows are closed. Ensure that
pets do not have access to the protected areas. Your installer may have instructed you to use a different
keypad to the one normally used to set the system.
LCD
Keypad:
The
ill
LED should be on. The screen shows the date and time:
Enter your code [0][1][2][3]. The exit beep starts.
Press
CD
. The exit tone stops.
Select part-set program [2) or [3]. The system set after a
short time. The
ill
LED goes out.
NOTE: There are no exit beeps
if
Silent
Timed
exit mode
has been programmed.
I
Program
1
Set
"1
or
3
SYSTEM
SET **
5
To Next Page
Loading...
Need help?
General
