How to
do
a Walk Test
User
Guide
How to do a Walk Test
Walk around your property, and in
tum
cause each detector to go into alann. Also, open and close
all door and windows that are protected by the system. For each detector (including door or window
sensor) that is activated the system produces a series
of
beeps, and the associated zone is indicated on
the keypad.
NOTE: Do not test any Personal Attack, Fire
or
Tamper keys during the Walk Test since these are
still active and will cause a full alarm.
If
any
of
the tests fail, or you are unsure
of
the correct procedure, contact your installer
CD then [0][11[2][3]
LCD Keypad:
Press
CD
and then enter your code [0][l][2][3]. The
00
LED goes
off
to indicate that you are in Programming mode.
The first menu
Walk Test appears on the screen.
00r[0]
Press 0
or
[0]. Zones 1-8 have a zero (0)
below each
TP
number.
00
I
When a zone is successfully tested, number 1 replaces the
O.
®
Zones are added
to
the list as each one is activated.
I
l0>wal.k
Test
Press ®
to
leave the menu
or
0 to restart the Walk Test.
LED keypad
Press
CD
and then enter your code [0][1][2][3]. The
00
LED
CD then
[0][1][2][3]
goes
off
and
the./'
LED comes on to indicate that you are
in Programming mode,
Walk Test.
12345678
@@@@@@@@
o@
--"~--@SO$
@
....
Press 0 or [0]. Zones 1-8 are off.
I @Ol
o
When a zone is sucsessfully tested, the LED is on.
Zones are added to list as each one is activated.
Press
® to leave the menu
or
0 to restart the Walk Test.
18
To Next Page
Loading...
