How to Silence an
Alarm··~
User Guide
LED
Keypad:
The
til
LED should be on.
Enter your code [0][1][2][3]. The exit beep starts.
Press the CD key. The exit tone stops and the zone LEDs
lto
3
come on.
Select part-set program [2]
or
[3]. The system sets after a
short time. The
til
LED goes out.
NOTE: There are no exit beeps
if
Silent Timed exit mode has been
programmed.
©sos
©.-"
I
@1iI
(6)~~(~~~
O'@
::.
[0][1][2][3] then CD
I
I
[2
or
3]
I
12345678
©©©©©©©©
O'@
__
__
©sos
"'~
©.-"
©1iI
How to Silence an Alarm and Reset the System
If
your system goes into alarm then be aware that intruders may
be in the premises. Seek assistance before investigating the
cause
of
the alarm.
LCD
Keypad:
Enter your code [0][ 1 ][2][3]. The alarm stops.
The
screen alternates, showing what caused the alarm
and
prompting for user reset.
When two
or
more alarms have occured, the first alarm
has
an
F below the zone number, Tamper
or
PA.
Subsequent alarms will have a
1 indicating where the
alarm has taken place.
Press
0.
The system resets and displays the date and time
if
there are no open Tampers,
PA
or
Fire zones to cause a
fault lockout.
The
system can be reset
by
the
user only
if
the installer
has programmed it to do so.
If
the message Engineer
Restore Required appears
on
screen then the user
must
contact the installer.
After
30
seconds the system displays the date and time.
6
Enter
Your
Code
I
[0][1][2][3]
Res~ored
by
User
Sunday
Oi-Jan
14:10
To Next Page
Loading...
Need help?
General
