Installation and Setup Guide
2-16
Powerline Carrier Devices
1. Install up to 4 powerline carrier devices (if no
relays are used) according to the instructions
included with each.
2. Connect the Powerline Interface Modulator
(XM10E) to the trigger pins as shown below.
3. Use Programming Mode to enter the device
house ID in data field*27, and enter the unit
code using *79 Output Device menu Mode.
Notes
• When using Powerline Carrier devices, you
must use a Powerline Carrier Device
Modulator. It supplies signals from the
control panel through the premises AC
mains wiring to the Powerline Carrier
devices (which are plugged into AC outlets).
You can then make devices that are plugged
into Powerline Carrier devices perform
various functions in response to commands
you enter at the security system keypads.
1 2 3 4
SA4120XM-1 CABLE
(PART OF 4120TR)
XM10E
POWERLINE
INTERFACE
MODULATOR
YEL
RED
GRN
BLK
MODULAR PHONE CORD (not supplied)
1 - BLACK
2 - RED
3 - GREEN
4 - YELLOW
SYNC
DATA
COM
1345678
KEY
+12 AUX.
DATA
COM
SYNC
GND (-)
OUTPUT 17
(RED)
OUTPUT 18
(GREEN)
(ORANGE)
(YELLOW)
(BLUE)
(PURPLE)
(BLACK)
00-trigcon-012-V0
8-PIN TRIGGER CONNECTOR
XM10E Powerline Interface Connections
To Next Page
Loading...
