Honeywell Ademco Vista-12D - Wireless Key Programming Templates

Installation and Setup Guide
5-10
PROMPT VALID ENTRIES EXPLANATION
Zn ZT P RC In L
10 03 1 10 RF: 1s
Note that an “s”
indicates that a
transmitter’s serial
number has been
enrolled.
Summary Screen
[∗] to continue
If the serial number transmitted matches the
serial number entered, the keypad will beep 3
times and a summary display will appear,
showing the programmed information for that
zone.
Press [∗] to begin programming the next zone. See
first “Summary Screen” prompt paragraph on
previous page.
Wireless Key Programming Templates
This procedure programs the wireless keys, but a key is not active until it is assigned to
a user number (see System Operation section, assigning attributes command).
If the D key was previously pressed (from *58 Menu mode) to enter and duplicate 5804
and/or 5804BD wireless keys, the following screens appear.
PROMPT VALID ENTRIES EXPLANATION
TEMPLATE ?
1–6 1
Template Number
1–3 = 5804 templates
4–6 = 5804BD templates
[∗] to continue
1. Enter Template number 1–6 (from
next page).
See the defaults provided for each
template in the chart that follows
these procedures.
2. Select from templates. Press [∗] to
display template (1 shown selected).
NOTE: If necessary, press [#] to
back up and re-enter template
number.
3. Press [#] if you want to return to
zone attributes screen.
L 01 02 03 04
T 23 22 21 23
Template Display
[∗] to continue
4. When [∗] is pressed, the selected
template will be displayed.
Top line of display represents loop
numbers, bottom line represents
zone type assigned for each loop.
5. Press [∗] to accept template.
PARTITION
1
Partition
1 = partition 1
2 = partition 2
3 = partition 3
[∗] to continue
6. Enter the partition in which the key
is to be active.
7. Press [∗] to continue.