Mounting and Wiring the Control
3-9
Loading Factory Defaults/Initializing for Download
To Load Default Entries
Press ∗97 while in Program Mode. This resets all data fields to
the default values shown on the Program Form. Use
∗
97 only if
you wish to return to the original factory-programmed defaults.
To Initialize Download ID
Press ∗96 while in Program Mode. This initializes the system for
downloading and resets all the subscriber account numbers and
CSID.
Do not press
✱
97 to load defaults if any programming has been done
previously—data already programmed into the system will be changed!
4
Exiting the Programming Mode
Prevent installer code reentry
Press ∗98. Exits Programming Mode and prevents re-entry by:
Installer Code + [8] + [0] + [0]. To enter the programming mode if
∗
98 was used to exit, you must first power the system down.
Then power up again, and press [∗] and [#] at the same time,
within 50 seconds of powering up.
Allow installer code reentry
Press ∗99. Exits Programming Mode and allows re-entry by:
Installer Code + [ 8] + [0] + [0] or by: Pressing [∗] and [#] at the
same time, within 50 seconds of power-up.
Table of Device Addresses
This Device Uses Address
Reports as
††
Enabled By…
RF Receiver 00 100 *56 zone programming: input device type entry
Alternative Communication
Media (ACM)
†
03 103 automatic if output to ACM field *29 enabled
Telecommand Voice Module 17-23 117-123 same as keypad enables; see below
Zone Expanders** (4219/4229):
zones 17 - 24
08
108
*56 zone programming: input device type entry, then:
automatic if zone no. 17-24 entered as AW type or
relay assigned
Keypads:
keypad 1
keypad 2
keypad 3
keypad 4
keypad 5
keypad 6
keypad 7
keypad 8
16
17
18
19
20
21
22
23
116
117
118
119
120
121
122
123
data field programming as listed below:
always enabled for partition 1, all sounds enabled.
data field *190
data field *191
data field *192
data field *193
data field *194
data field *195
data field *196
5800TM Module 28 n/a automatic
† ACM devices include: 7845i Ethernet Interface Internet/Intranet, AI4164RS/AI4164ETH RS485/Ethernet
Eureka Network Interface
†† Addressable devices are identified by “1” plus the device address when reporting. Enter a report code for
zone 91 to enable addressable device reporting (default = reports enabled). See field *199 for addressable
device (ECP) 3-digit/2-digit identification keypad display options
.
** or 6164 Keypad using zones; 08 = zones 17-20
To Next Page
Loading...
