Installation and Setup Guide
5-4
PROMPT
VALID ENTRIES EXPLANATION
17 INPUT TYPE
RF TRANS 3
Input Device type (In)
2 = AW (Aux wired zone)
3 = RF (supervised RF
transmitter,
4 = UR (unsupervised RF
transmitter)
5 = BR (unsupervised button
type RF transmitter)
7 = RM (supervised RF motion
detector)
[∗] to continue
This prompt is skipped for zones 10-14 if zone-
doubling was enabled at “Hardwire Type” prompt.
All of the RF transmitters have one or more
unique factory-assigned input (loop) ID codes.
Each of the inputs requires its own programming
zone (e.g., a 5804's four inputs require four
programming zones).
RF Transmitters can be enrolled as one of the
following types:
Type Description
“RF” Sends periodic check-in
signals, as well as
(Supervised RF) fault, restore, and low-
battery signals. The
transmitter must stay
within receiver's range.
“UR” Sends all the signals that
the “RF” type
(Unsupervised RF) does, but the control does
not supervise the check-in
signals. The transmitter
may therefore be carried off-
premises.
“BR” (Unsupervised Sends only fault signals. It
does not send a
Button RF) low-battery signal until it is
activated. The transmitter
may be carried off-premises.
“RM” Sends periodic check-in
signals, as well as fault
(Supervised RF and low- battery signals. The
panel ignores
Motion Detector) detector restore signals but
automatically restores the
zone to “ready” after a few
seconds. Designed for
facilities with multiple
motion detectors that may
fault and restore
simultaneously. The
transmitter
NOTES: must remain within the
receiver’s range.
• For the built-in basic wired zones, the Input
Device type is automatically displayed as HW
and cannot be edited.
• To change the input type of a previously
programmed wireless device (type RF, UR, BR,
RM) to a wired zone (type AW), you must first
delete the transmitter’s serial number
To Next Page
Loading...
